7103-11 5213 BSD-Projection Screens-Addendum 317190 / American Legion Senior
Center
11 5213 - 1 PROJECTION SCREENS
SECTION 11 5213
PROJECTION SCREENS
PART 1 GENERAL
1.01 SECTION INCLUDES
A.Front projection screen assemblies.
1.02 SUBMITTALS
A.See Section 01 3000 - Administrative Requirements, for submittal procedures.
B.Product Data: Manufacturer's catalog cuts and descriptive information on each product to be
used, including:
1.Preparation instructions and recommendations.
2.Storage and handling requirements and recommendations.
3.Installation methods.
C.Warranty: Submit manufacturer warranty and ensure that forms have been completed in
Owner's name and registered with manufacturer.
1.03 DELIVERY, STORAGE, AND HANDLING
A.Deliver projection screens to project site in manufacturer's original unopened packaging, and
inspect for damage and proper size before accepting delivery.
B.Store in a protected, clean, dry area with temperature maintained above 50 degrees F, and
stack in accordance with manufacturer's recommendations.
C.Acclimate screens to building temperatures for 24 hours prior to installation, in accordance with
manufacturer's recommendations.
1.04 WARRANTY
A.See Section 01 7800 - Closeout Submittals, for additional warranty requirements.
PART 2 PRODUCTS
2.01 FRONT PROJECTION SCREENS
A.Manufacturers:
1.Bretford: www.bretford.com/#sle.
2.Da-Lite Screen Company: www.da-lite.com/#sle.
3.Draper, Inc (Manual); Luma Series: www.draperinc.com/#sle.
4.Stewart Filmscreen Corporation: www.stewartfilmscreen.com/#sle.
5.Substitutions: See Section 01 6000 - Product Requirements.
B.Front Projection Screens: Factory assembled unless otherwise indicated.
1.In areas as indicated on drawings: Manual, matte light diffusing fabric screen, horizontally
tensioned, wall mounted.
a.Products: Luma 207003 manufactured by Draper.
C.Matte Light Diffusing Fabric: Light diffusing screen fabric; washable, flame retardant and
mildew resistant.
1.Material: Matte white vinyl on fiberglass backing, with nominal gain of 1.0 over viewing
angle not less than 70 degrees from axis, horizontally and vertically.
2.Seams: No seams permitted in fabric up to 96 inch high by 72 inch wide.
D.Exposed Screen Cases: Steel, with integral roller brackets.
1.Finish: Baked enamel.
2.Color: White.
3.End Caps: Steel; finished to match case.
4.Mounting: Wall.
E.Manually-Operated Screens:
1.Roller: 1-3/4 inch aluminum; spring loaded with locking device.
2.Screen Pull: Ring on bottom bar.
17190 / American Legion Senior
Center
11 5213 - 2 PROJECTION SCREENS
3.Vertical Tensioning: Screen fabric weighted at bottom with steel bar and plastic end caps.
4.Horizontal Tensioning: Tensioning bar.
F.Provide mounting hardware, brackets, supports, fasteners, and other mounting accessories
required for a complete installation, in accordance with manufacturer's recommendations for
specified substrates and mountings.
PART 3 EXECUTION
3.01 INSTALLATION
A.Install in accordance with manufacturer's instructions, using manufacturer's recommended
hardware for relevant substrates.
B.Do not field cut screens.
C.Install screens in mountings as specified and as indicated on drawings.
D.Install plumb and level.
E.Adjust projection screens and related hardware in accordance with manufacturer's instructions
for proper placement and operation.
END OF SECTION